Carbide burs are among the most in-demand and versatile cutting tools employed in just about any industry. Made of Tungsten Carbide these are primarily used to remove burrs (the little flakes of metal) that always remain on the job piece following your machining process. Burs can be purchased in standard lengths long series (for challenging to reach applications) along with miniature sizes (for usage in pencil grinders).
Features
Solid carbide tools offer long tool life and faster cutting speeds than other substrates, but they are more brittle and has to be used with rigid tool holding systems
Uncoated tools feature exactly the base substrate without additional treatment or coatings and so are suitable for many applications
Round shanks allow use having a wide variety of tool holding systems
Double-cut style has rows of cutting teeth cut in two intersecting directions for fast material removal along with a rougher finish
For deburring, interior contour work
CUT TYPE
Singlecut
General purpose tool for surefire, copper, brass and steels
Fairly aggressive cutting action, with good material removal rates
This tool leaves a nice finish on most all materials, however the bite can be demanding on operators
Doublecut
For general purpose use including surefire, copper, brass and steels
The Doublecut runs on the cross flute of exactly half the number of standard flutes within a opposing helix
Sliver dimension is cut down tremendously, as they are the operator fatigue through the balanced cutting forces
Lower RPMs may be utilized with little negative impact on performance
The decreased load equals operator’s often feeding it more aggressively
Alumacut
Great for all non-ferrous, non-metallic workpieces like aluminum, zinc, plastic, wood, etc.
An incredibly aggressive cutting action, with little if any possibility of plugging these flutes up
Diamondcut
Is often a finer cut of opposing helixes
Operating control is superb as the biting action is restricted as they are the silver size produced from it
This version is usually preferred to get where titanium and also other difficult materials (superalloys) are deburred
Using the teeth being smaller and a little more fragile because of this, tool life’s not normally a few import
Fiberglass will cut nicely with Diamondcut
Chipbreaker
Another sort of the Doublecut, it is a slightly less aggressive tool whose main objective is usually to simply interupt the cut
One, opposing helix is ground within a spiral throughout the tool, typically
Silver size decreases, surface finish decreases marginally, hand control climbs up, marginally
Check out about https://www.burrs4less.com/sa-9-31.html check out our new resource
Be First to Comment