The primary things the do-it-yourselfer realizes when learning building a drywall ceiling is always that no man is surely an island – unless he uses rented equipment! For the reason that panels are big, bulky, and awkward, hanging drywall with a ceiling entails one or other: the assistance of someone else or renting a drywall jack from the local home improvement center. The cable mechanism on drywall jacks just isn’t tough to operate, and jacks do an outstanding job of holding the drywall within a secure, flat position enabling you to more easily attach it to the ceiling.
Tools & Materials
How to construct a Drywall Installation Video includes knowing what all tools and material you will need. In addition to either someone else that may help you or a drywall jack, you can also require a hammer, a drill with a screwdriver bit, and nails or screws for drywall. You will also, of course, must measure your ceiling (twice!) and get enough drywall, with a little extra in the case of mistakes, to do the job.
Mark Joists First
Discover the boards – usually 2x4s or 2x6s – that work as ceiling joists by tapping across the wall studs with a hammer and following inside the wall to the ceiling. Included in learning to create a drywall ceiling, mark where these boards are situated with a pencil. They’re what you will be attaching the drywall to and marking them beforehand makes it quicker to see them than attempting to find them since you are nailing or screwing for the drywall. After this you must measure where the permanent fixture continues the drywall and cut out a dent to accommodate that portion of the ceiling.
The Tough Part
Its part in learning building a drywall ceiling where you will need the other person (who hopefully has a good amount of stamina in addition to strength!) to carry the drywall up to the ceiling as well as to put the drywall panel for the jack. Placed the end with the sheet of drywall – using its finished side facing down – in the center with the ceiling board (joist) that you’re going to nail it. Nail across the away from the panel in regards to a one-half inch through the edges to avoid the drywall from splitting or cracking. The individual that is holding the panel are now able to move or, in case you are using a jack, you can move it of the way.
Ensure it is Pretty
Countersink nails or screws at six- or seven-inch intervals all across the whole joist that the drywall may be attached. Countersinking enables you to mask the heads with the nails/screws with compound in order that if you paint, the heads will not be whatsoever visible. However, not a legitimate portion of knowing how to construct a drywall ceiling, learning to mask ugly nail or screw heads serves its very own purpose for overall general carpentry knowledge.
To learn more about Drywall Installation Video visit our new internet page: read this
Be First to Comment